Thingiverse
Auto Power Off Project
por Botcan3d
23
Descargas
16
Likes
0
Makes
3D PRINTER AUTO POWER OFF (filament runout or print end)
The aim of the project is to auto power off the 3d printer:
a) when filament runs out or;
b) when the print ends (requires a simple g-code modificaiton described below)
using external hardware (no influence to internal parts of the printer).
WARNING: Safety First! Dealing with high voltage (ie 110/220V) is dangerous and may harm you or worse. Please disconnect all electricity plugs before you do any modification on the power outlets/plugs and cables. Take care of short-cuts, weak cables, connections and switches which may also casue burns and other fire risks.
WARNING & DISCLAIMER: This DIY project is not a proffessional study. Failure of proper working of the parts or devices may cause harm to you and to your printer (including power off through unpluging process instead of using the original on/off switch on the printer and force Z stepper to exceed "print-end" switch height). Accordingly, install and use the Project
The aim of the project is to auto power off the 3d printer:
a) when filament runs out or;
b) when the print ends (requires a simple g-code modificaiton described below)
using external hardware (no influence to internal parts of the printer).
WARNING: Safety First! Dealing with high voltage (ie 110/220V) is dangerous and may harm you or worse. Please disconnect all electricity plugs before you do any modification on the power outlets/plugs and cables. Take care of short-cuts, weak cables, connections and switches which may also casue burns and other fire risks.
WARNING & DISCLAIMER: This DIY project is not a proffessional study. Failure of proper working of the parts or devices may cause harm to you and to your printer (including power off through unpluging process instead of using the original on/off switch on the printer and force Z stepper to exceed "print-end" switch height). Accordingly, install and use the Project
Botcan3d también publica en
6 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
