Thingiverse
Autococker Beavertail Snatch Grip
by Rklenke
3
Downloads
0
Likes
1
Makes
After a couple refinements, I've combined my beavertails. Currently they match profiles of the Shocktech Gunfighter 1.5 frame and ANS QuickFire 45 frame. I'll add more frame matching at some point.
I designed this to be useable with or without a 10/32 beaver tail. Printed as is, it can be used as a snatch grip. The print is threaded, but I found that I still needed to run a 10/32 threaded die through it to clean it up before I could thread in the beavertail.
Gunfighter tail - original design, has threaded hole
Gunfighter tail v2 - new design, resembles a shocktech tail, has threaded hole
Gunfighter tail v3 - new design, no threaded hole. Just a snatch grip
Quickfire tail - original design, has threaded hole
Quickfire tail v2 - new design, resembles a shocktech tail, has threaded hole
Quickfire tail v3 - new design, no threaded hole. Just a snatch grip
I designed this to be useable with or without a 10/32 beaver tail. Printed as is, it can be used as a snatch grip. The print is threaded, but I found that I still needed to run a 10/32 threaded die through it to clean it up before I could thread in the beavertail.
Gunfighter tail - original design, has threaded hole
Gunfighter tail v2 - new design, resembles a shocktech tail, has threaded hole
Gunfighter tail v3 - new design, no threaded hole. Just a snatch grip
Quickfire tail - original design, has threaded hole
Quickfire tail v2 - new design, resembles a shocktech tail, has threaded hole
Quickfire tail v3 - new design, no threaded hole. Just a snatch grip
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
