Autodarts Leg and Ring

Autodarts ring and arms. The arms are printed in 2 parts and connected with M3 x 10mm screws and nuts, no glue is required. The cable can be brought into the head through the groove and fixed from behind with the small clamps. The cameras are attached to the arm with a bracket and another screw. The ring is printed from 12 parts, which can then be inserted into each other, again without the need for glue. The ring can then also be attached to the arms using the M3 screws. The ring cover segment is not absolutely necessary, but it enhances the final result. Additionally there is an arm which can be used for the led strip to hide the cable and lead it away from the board. You will also need the cameras you can find online and a led strip that you can stick inside the ring. For a complete set with ring you need:9x Ring segment 2x Ring to Leg Segment 1x Ring to Leg Segment for Led12x Ring cover segment 12x Clip for Ring cover Segment 2x Autodarts Leg1x Autodarts Leg for Led12x Leg Clip Cab