Slicer Discord
Autolock – 3D printable model from MakerWorld MakerWorld
Other Tools

Autolock

12 Downloads
16 Likes
6 Makes
Go to Model
Let me introduce you to my new creation.It all started when I was looking to secure a wooden swing door in my van to prevent it from opening while traveling.The advantage of this mechanism is that it's fully automatic: all you have to do is push the door!To unlock, simply push the yellow lever a few millimeters and pull your door open, using only one hand.If your door covers the furniture (for example, a kitchen cabinet door), you'll simply need to drill a hole opposite the yellow lever and use a pin to unlock it.For assembly, you'll only need two 3x10mm screws.I recommend pre-tensioning the spring before tightening the central screw: that is, don't align the hole in the end of the spring with the hole in the yellow lever. Move the spring hole down a few millimeters before tightening the pivot screw, and then insert the last screw.This will have the advantage of gently pressing the lever into the lower position.For installation in your closet, you'll only need six w
Category
Other Tools
Source
MakerWorld
Published
Updated
What you need to print this: Intermediate Low confidence
Single piece Hardware needed
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Wood PLA
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection