Automatic nozzle cleaning station

EN: Printed PET-G into a nightmare, after heating the nozzle, some of the material sags and you have to pick it up with tweezers - so it doesn't get under the print. I haven't found any holder that fits me and that would be universal, so design your own. The other available solution brings the topic down to reworking the X axis, which is what I wanted to choose. I believe this model is universal and should fit the machine. The brush is within the contour of the table, so you don't have to move the x-edge to access the brush tracking. The thinner base also works as there is a screw hole on the underside so it is blogi and held in place. The brass brush is to the point that it will not damage so it allows for good cleaning. Keep in mind: Also make sure you push the brush in well, you can always paste it The attached one can be added to the boot code Preferences -> Printers -> Machine settings -> Startup G-Code mount the brush, and then on carrying out through the controller the nozzle on