Thingiverse
Avon C50 Plug Wrench/Tool
door DaedalusZero
0
Downloads
0
Likes
0
Makes
Simple wrench I designed to remove the pre-installed plug in the C50 right-side port without too much damage.
This is usually done to swap the filter side when used single port or allow filters to be used on both sides (dual port).
The prongs are not angled like the real thing so I can't guarantee it will tighten the plug sufficiently.
Mine was printed in PLA+ with 2 walls and 15% infill and it works fine.
I recommend setting X-Y contour compensation in Bambu Studio/Orca Slicer to -0.2mm if the prongs are too tight.
This is usually done to swap the filter side when used single port or allow filters to be used on both sides (dual port).
The prongs are not angled like the real thing so I can't guarantee it will tighten the plug sufficiently.
Mine was printed in PLA+ with 2 walls and 15% infill and it works fine.
I recommend setting X-Y contour compensation in Bambu Studio/Orca Slicer to -0.2mm if the prongs are too tight.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
