Thingiverse
AVR Dragon Case
von Conceit
0
Downloads
0
Likes
0
Makes
A case for the good old AVR Dragon programmer/debugger. I have completely redrawn this after a failed approach to remix [Farin's AVR Dragon Enclosure](https://www.thingiverse.com/thing:2979167). The original design was done as a sheet-cut by Brian Dory ([Blog Entry](https://www.briandorey.com/post/atmel-avr-dragon-programmer-case)).
However, since things were cut out of flat sheets, there were some issues that could be fixed in the 3d world:
- The original design had no feet, thus bottom screws/nuts scratched over the table.
- There was quite some play (around 2 mm) for the board to tilt and rattle inside the box. The new design now has PCB holders that fit to the holes of the dragon board and some gap fillers.
- The cutout was for using all debug interfaces, including the IC swap sockets (which probably wouldn't fit anyways, not sure). I reduced the cut out to the necessary (for me).
If you need a top sheet with complete cut out, you can drop me a comment here.
You can u
However, since things were cut out of flat sheets, there were some issues that could be fixed in the 3d world:
- The original design had no feet, thus bottom screws/nuts scratched over the table.
- There was quite some play (around 2 mm) for the board to tilt and rattle inside the box. The new design now has PCB holders that fit to the holes of the dragon board and some gap fillers.
- The cutout was for using all debug interfaces, including the IC swap sockets (which probably wouldn't fit anyways, not sure). I reduced the cut out to the necessary (for me).
If you need a top sheet with complete cut out, you can drop me a comment here.
You can u
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!