MakerWorld
Vehicles
Go to Model
Awning endstop for Caravan - Ø7,8x20 M3
10
Downloads
2
Likes
5
Makes
Found out that the previous owner had destroyed the tent rail/frame rail/awning rail when I was going to replace the awning. So I printed a stopper that was a little smaller than the original, but still does the same job. Printed the hole with M3 threads. The thread is tight, but no problem when you use an Allen key when screwing in an M3 set screw. Hope this can be helpful to others too! Boost MePlease give me a boost if this was helpful to you! Thanks! :D
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
