Thingiverse
Awning Gutter Clip
von joebywan
9
Downloads
8
Likes
0
Makes
If you're out caravanning or camping you know how rain coming off your awning turns your outside area to mush. This is put along the end of your awning to turn it into a gutter, which you can then direct the water to a bucket for use while you're on the road, while also helping top the rain digging a trench off your awning.
Should be printable without supports, I modelled it for someone who didn't want it after, so I'm putting it up here.
It's supposed to be strong, so biggest layers you can manage. I'd suggest ABS/PETG/ASA because it'll be outside, but I imagine that with PLA in the rain it shouldn't be an issue unless you leave them out until the sun starts beating down again.
Should be printable without supports, I modelled it for someone who didn't want it after, so I'm putting it up here.
It's supposed to be strong, so biggest layers you can manage. I'd suggest ABS/PETG/ASA because it'll be outside, but I imagine that with PLA in the rain it shouldn't be an issue unless you leave them out until the sun starts beating down again.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
