Thingiverse
Awning Handle Cover
von PDPrints
3
Downloads
4
Likes
0
Makes
Awning Handle Covers broke, so i had to print new ones.
They are a bit tricky to glue up, i used superglue (be careful not to glue up
your fingers as i did).
I printed them in PETG but since they are outside and are exposed to a lot of
sunlight i would recommend to use ASA.
PETG is still going strong after 3 years though.
Use Support!
They are a bit tricky to glue up, i used superglue (be careful not to glue up
your fingers as i did).
I printed them in PETG but since they are outside and are exposed to a lot of
sunlight i would recommend to use ASA.
PETG is still going strong after 3 years though.
Use Support!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
