Thingiverse
Axe Throwing Target Stencil
by HPSilhouette
11
Downloads
7
Likes
0
Makes
This is a close approximation of the 2021 World Axe Throwing League (WATL) target stencil.
Print your own for personal use only.
Scoring ring slots are approximately 5/16 x 25/32" (8x20mm).
Print 2 halves (top and bottom) and glue together with epoxy or super glue. Overall finished length is about 61cm (24").
Recommend you sand glue tabs lightly before applying glue for maximum adhesion. Clamp until glue hardens.
Enjoy!
Print your own for personal use only.
Scoring ring slots are approximately 5/16 x 25/32" (8x20mm).
Print 2 halves (top and bottom) and glue together with epoxy or super glue. Overall finished length is about 61cm (24").
Recommend you sand glue tabs lightly before applying glue for maximum adhesion. Clamp until glue hardens.
Enjoy!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!