Thingiverse
Axial Wraith Winch Fairlead
door Brainanator
84
Downloads
63
Likes
1
Makes
This is a simple fairlead for the Axial Wraith. Mainly applicable if using a servo winch setup. Designed around the stock servo on axle setup, I have not tested with a CMS setup, and I don't have any interest in putting CMS on my Wraith at this time.
To use, I highly recommend drilling out the mounting holes on the wraith to 3.0mm. I don't recommend 1/8", If you don't have a drill bit, just use a 3mm screw and strip the hole out completely.
There are 2 version. The first version is if you have removed the stock front bumper light buckets. The second version moves the fairlead back, and makes it more narrow to allow the use of the light buckets.
You will need to change screws to mount this:
No-lights: M3x8
Lights: M3x12
The screws will cut their own threads into the fairlead holes, DO NOT OVER TIGHTEN. If you are an extreme user feel free to use longer screws and locknuts.
To use, I highly recommend drilling out the mounting holes on the wraith to 3.0mm. I don't recommend 1/8", If you don't have a drill bit, just use a 3mm screw and strip the hole out completely.
There are 2 version. The first version is if you have removed the stock front bumper light buckets. The second version moves the fairlead back, and makes it more narrow to allow the use of the light buckets.
You will need to change screws to mount this:
No-lights: M3x8
Lights: M3x12
The screws will cut their own threads into the fairlead holes, DO NOT OVER TIGHTEN. If you are an extreme user feel free to use longer screws and locknuts.
Brainanator publiceert ook op
14 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
