Thingiverse
Axis 1065 Camera Mount
0
Downloads
1
Likes
0
Makes
A simple holder for holding an Axis network camera above a monitor. The bottom part will be specific to my monitor, but you can modify it to suit your own. The camera holder part is tilted at a 15 degree angle.
This allows for the camera to be mounted above a monitor. In our case, it is being used for subject monitoring during behavioral experimentation. This camera has good low light capabilities as it is an IR camera. It also has a bit of a fish eye lens, so you get good coverage.
One half inch long 1/4 inch bolt is required to mount the camera. A washer might be needed as well. I would strongly consider thread locker if your monitor is mounted to an arm and moved about regularly.
Developed by Graham Holt at the Laboratories of Cognitive Neuroscience of Boston Children's Hospital.
This object was modeled in TinkerCAD.
This allows for the camera to be mounted above a monitor. In our case, it is being used for subject monitoring during behavioral experimentation. This camera has good low light capabilities as it is an IR camera. It also has a bit of a fish eye lens, so you get good coverage.
One half inch long 1/4 inch bolt is required to mount the camera. A washer might be needed as well. I would strongly consider thread locker if your monitor is mounted to an arm and moved about regularly.
Developed by Graham Holt at the Laboratories of Cognitive Neuroscience of Boston Children's Hospital.
This object was modeled in TinkerCAD.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
