Thingiverse

Axis Caliper Alignment Jig

von Coder-Tronics

273 Downloads

163 Likes

1 Makes

I recently upgraded my Wanhao Di3 to a RAMPS v1.4 running Repetier v0.92.9, partly as I wanted some extra functionality with the latest release and more control and also because I have had 2 Melzi boards fail on me now within 18 months!

The upgrade wasn't too hard but takes a bit of time getting everything calibrated and functioning correctly, one of the issues I found was tuning the steps per mm for the X, Y and Z axis (to a decent tolerance).

https://youtu.be/sEtmlaI2Q9c

This is where the **Axis Caliper Alignment Jig** came about, the video should explain everything and this should work on most metal framed Prusa variants, but I am sure this is easily remixed to accommodate most printer setups.

All parts are designed to be printed without support, see the orientation image for the main caliper block, the angled edges are all above 45 degs.

**Couple of further notes:**

1) I only show Repetier software here, it is also possible to enter Gcode directly to produce the s

Axis calibration axis alignment caliper caliper alignment caliper bracket caliper holder Duplicator i3 Wanhao malyan m150 monoprice monoprice makerselect vernier caliper Wanhao Duplicator I3 Wanhao I3 Axis calibration axis alignment caliper caliper alignment caliper bracket caliper holder Duplicator i3 Wanhao malyan m150 monoprice monoprice makerselect vernier caliper Wanhao Duplicator I3 Wanhao I3 Axis calibration axis alignment caliper caliper alignment caliper bracket caliper holder Duplicator i3 Wanhao malyan m150 monoprice monoprice makerselect vernier caliper Wanhao Duplicator I3 Wanhao I3

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Warum?

keine Supports

Ohne Supports Einteilig

Supports 0/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker