Axle Mount for Spool Holder

Hi there!

This is my fist "official" little project, so please be patient if
something goes wrong. I did some other things before and will add
them here too, but I still consider myself as a noob. :)

I recently got a free cabinet which perfectly fits my 3D Printer.
It also had a compartment for mounting filament rolls. All I needed
were proper mounts for the axles.

Requirements:

1 10mm (or smaller) axle and two matching nuts per roll to mount.
The length should be at least 10-12mm shorter than the space you
want to mount it between, as the axle mount base plate is 5mm
thick and you need one on each side.

4 4mm screws for wood mounting to fixate the axle holder.

1 Spool holder

The spool holder itself is a remix of a great and simple design I found
on thingiverse. There are probably tons of great spool adapters around,
so just pick one that fits on your axle.

I used this one before with the original holder that came with the printer