Thingiverse
B-daman Bolas Shot
6
Downloads
4
Likes
0
Makes
A weird strike shot that as usual barely works, but hey it's fun to use.
Print two Center pieces and four Halves, run some twine through the center hole and tie a knot that will stop the twine from slipping out. Once both Centers are tied together glue the two halves together, there should be enough room to slide the holes over the center properly, so it would fit and fire out a b-daman decently.
Print two Center pieces and four Halves, run some twine through the center hole and tie a knot that will stop the twine from slipping out. Once both Centers are tied together glue the two halves together, there should be enough room to slide the holes over the center properly, so it would fit and fire out a b-daman decently.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
