Babyhawk Simple Bumper

Just designed this prop bumper for my babyhawk so I can reduce weight and still have some protection. I have not printed it yet and don't know how much weight it saves. It's designed to be 1.5mm thick where the mounting screws are so it should allow the reuse of the same screws without interfering with the motors. But always measure yours to be sure.

*** Edited the screw hole spacing. Made an error laying it out originally. Should be 8.3mm center to center diagonally.

*** Opened up the center hole as the BH has a short tube under the motor. The hole alignment was good but I felt like it was too heavy and overly built so I created a lighter V2 version. two of the V2 guards weigh 2.36 grams compared to the original 3.55 grams.