Slicer Discord
Back to School SAFETY KIT – 3D-Druckmodell von Thingiverse Thingiverse

Back to School SAFETY KIT

2 Downloads
2 Likes
0 Makes
Zum Modell
Pioneers in bringing to Brazil the most modern in terms of protection against COVID_19, disruptive materials, which are not in a conventional evolutionary line, but in a revolutionary line and that promoted radical changes in the fight against the pandemic. Polymers with broad spectrum antimicrobial active nanotechnology from Copper 3D. Materials proven effective in eliminating any virus, bacteria or fungi, approved by the European Union, FDA (Food and Drug Administration) with all ISO's of the respective certifications including FOOD SAFE Guaranteed safety in contact with food

We are launching the products of #HackThePandemic campaign focused solely and exclusively on avoiding, with validated effectiveness, the cross-contamination of viruses and bacteria that we are subject to encounter in our daily lives. Whether in our homes, workplaces and indoor or outdoor social living areas.

These materials are currently used by NASA on the International Space Station (ISS).


We have
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, ASA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen