Thingiverse
Backpack drone hanger
von veujin
84
Downloads
69
Likes
2
Makes
Hanger for 5" drones. Designed to use with 20mm battery strap.
I used m3x10 screws for it. Also I used 2-sides sticky tape between outer part and backpack to waterproof backpack content.
Printed out of abs with 50% infill.
I used m3x10 screws for it. Also I used 2-sides sticky tape between outer part and backpack to waterproof backpack content.
Printed out of abs with 50% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
