Thingiverse
Badass Spool Roller for MP Select Mini
door auralgasm
164
Downloads
91
Likes
1
Makes
Spool holder / roller for MP Select Mini. This will hold the regular sized spools as well as the smaller ones.
A little background if you care to read. Goal was to design a stylish, badass looking, over-engineered, impractical non-cost effective roller.
Hardware required:
(1) 1/4” threaded rod, 92mm in length (recommend cutting it a bit shorter, 91mm works) - home depot
(3) R4-ZZ ball bearings 1/4”(ID) x 5/8”(OD) x .196”(Width) - eBay
Assembly:
Screw rod into spool_holder, refer to photo for proper sequence of parts.
A little background if you care to read. Goal was to design a stylish, badass looking, over-engineered, impractical non-cost effective roller.
Hardware required:
(1) 1/4” threaded rod, 92mm in length (recommend cutting it a bit shorter, 91mm works) - home depot
(3) R4-ZZ ball bearings 1/4”(ID) x 5/8”(OD) x .196”(Width) - eBay
Assembly:
Screw rod into spool_holder, refer to photo for proper sequence of parts.
auralgasm publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!