BadBug RC Glider

BadBug by JGAF

Bambu Studio Slicer Video:
https://www.youtube.com/watch?v=rMsjDzWOo3E&ab_channel=JGAF

Build video: https://youtu.be/3n9O9Qy3PyM?si=kHTtoEUOkzyJJOKB

v.2
26" wingspan

Required to complete:
9g or smaller servos, 1s lipo battery, receiver, transmitter
1.5mm rod, CA glue

LW PLA or (recommended) CF PP filament - TPU or CF PP for hinges

***approximate C.G. 1/8" behind optional joiner tube line

Throws 3/16" up/down and (3/16" - Maximum) left/right

I'm a homeless full time college student, tips are appreciated:
https://www.paypal.com/biz/profile/slopecorn

3D printing settings
print nose section and center sections behind canopy with 10% honeycomb infill, .4mm line width

print canopy at .3mm line width from clear filament to mimic effect in sample photos

print everything else in vase mode

"recommend cf-pp or lw pla non-foaming, active foaming if you know what you're doing. print mid sections excluding fin with infill (gyroid or whatever)