Thingiverse
Badger2040 Enclosure
door FancyImpactBlasters
9
Downloads
4
Likes
0
Makes
Update - Now contains a version with a small rear cutout to allow access to the rear buttons
Simple to print enclosure for the Badger2040, this enclosure allows power and the lanyard connection from the sides. If you also print the sliding door then it will also hold a small LiPo battery inside meaning no Velcro is needed to hold it in place.
This was created for my purposes, but I'm guessing other people may want this design too.
4xM2 screws and no nuts required.
Simple to print enclosure for the Badger2040, this enclosure allows power and the lanyard connection from the sides. If you also print the sliding door then it will also hold a small LiPo battery inside meaning no Velcro is needed to hold it in place.
This was created for my purposes, but I'm guessing other people may want this design too.
4xM2 screws and no nuts required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
