Slicer Discord
Bag holder for ABC Stroller – 3D-Druckmodell von Thingiverse Thingiverse

Bag holder for ABC Stroller

31 Downloads
15 Likes
0 Makes
Zum Modell
German translation below!

These are two holders for hang in a changing bag (napkin bag) over the stroller. This is made for Strollers of the Brand ABC Design, but could also used for other strollers with with oval profile of diamter 3.2CM x 2.0 CM.
I succesfully tested it with the models ABC Mamba and Cobra.

if you use the shorter part on the left side, the stroller will stay foldable with both hangers.


Wickeltaschenhalterung für ABC Design-Kinderwagen. Die Halterungen gehen an alle Kinderwagen, mit ovalen Stangenquerschnitt mit den Abmessungen 3.2 CM x 2.0 CM. Erfolgreich getestet habe ich es an den Modellen ABC Mamba und ABC Cobra. Nutzt das kürzere Teil auf der linken Seite, damit der Wagen noch mit den Haken zusammenklappbar bleibt.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen