BagClip+

Unlike most 3d printed clips these are designed to be simple but have good tension from the start. You'll find hundreds of uses for these. Chip clip, LED string light clip, Towel holder, Clothes line clip, Note hanger.Print it as is. Let it cool down completely then cross over the ends to form the clip.I have used PETG, PLA+, PETG-CF so far and they work well. You should use 2 walls at .6 nozzle, 3 for .4 nozzles. Supports are recommended but not required. Try rescaling to different sizes, 70% 125%, 150%, etc. Lots of fun uses for these. If you make them larger they get quite strong. After time most plastics will lose their tension. You can re-tension these buy opening them up and soaking the circular part in warm/hot water for a few seconds. Remove from the water and hold it open while it cools. Running under cold water is a quick way to cool it off. Then close it back up and it will have full tension. So far the PETG-CF has been pretty good at maintaining tension the longest. I a