Bagpipe Chanter Cover

This is a protector for a bagpipe chanter while not in use. I printed this with transparent PETG with 0.5mm walls and 2mm layer heights. The enclosure is printed with just two walls on the sides to allow transparency. Enclosure is not 100% see through due to the nature of curves and transparent material, but you can still see the reed through the cover as shown in the pictures. 5 Vent holes are located at the top of the print to allow moisture to escape, and to prevent rotten reeds. Assembly: Materials needed are one M5 hex nut (~3mm thickness and 8mm wrench size) and an M5 bolt. Printing pauses at layer 83 to allow you to pop in a nut (points up and down) and resume printing. After print is complete, screw in the bolt, and slide it onto your chanter when not in use. EnjoyBoost MeBoooooooooooooooooooooost