Thingiverse
Balancer for large and medium models
von Rom119
1
Downloads
1
Likes
0
Makes
Balancer for large and medium models.
Bearings 22x8x7mm
Spruce prism 20x20mm
M8x70 screw with nut and washer
The height must be made according to your own model.
Glue the upper part with poster adhesive to the center of gravity and then place the model on the stand.
The smaller support is under the back of the model, height at your discretion.
Bearings 22x8x7mm
Spruce prism 20x20mm
M8x70 screw with nut and washer
The height must be made according to your own model.
Glue the upper part with poster adhesive to the center of gravity and then place the model on the stand.
The smaller support is under the back of the model, height at your discretion.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!