Thingiverse
Balco Filament Holder Roller
door witcombem
0
Downloads
0
Likes
0
Makes
My Balco printer came with a 500g roll of filament. Everything worked fine. I then purchased a 1kg roll and things went bad. The prints looked like they were being starved of plastic (had holes). I then realised the new 1kg roll was not being rolled easily. So, I made this new holder.
Takes 3 x 10mm wide, 12mm core (hole dimension) bearings. The outside diameter is your choice. I use 32mm diameter ones.
In the photo you will see the original black nut that came with the Balco. The printed parts are white PLA.
I used a 40% infill for strength.
Print the thread and nut with support turned off.
Takes 3 x 10mm wide, 12mm core (hole dimension) bearings. The outside diameter is your choice. I use 32mm diameter ones.
In the photo you will see the original black nut that came with the Balco. The printed parts are white PLA.
I used a 40% infill for strength.
Print the thread and nut with support turned off.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!