Ball in a Box

I designed this **Ball in a Box** when I started experimenting with different filaments. I wanted something to try with PVA supports. I printed this a few different ways including single extrusion, dual extrusion, PLA with PVA supports, and TPU with PVA supports (not pictured).

Pictured:
PLA Blue/Red
PLA Orange
PLA Pink / PVA Supports

It is a fun little model to play with. The ball could be squeezed out in the TPU version, but a day of play broke the box on that one. I haven't yet tried TPU ball and PLA box.

Supports are needed for the ball. When setting up the print, I also raised the models up slightly so the bottoms of the box sphere corners would be nestled in supports rather than sticking to the print bed directly since I was having trouble with that. For the PVA print, I included a raft since the PVA was not sticking to the bed.

I also used this to do a little experimenting with bridging and supports. The best prints for the box were when I included supports, but t