Bamboo Pot

Faux stained glass. Frame prints upright, "glass" pieces print
upside down. Flip "glass" pieces over after printing and insert into
upright frame. Pic of model shown was printed using only 2 layers
for glass, but I prefer to use honeycomb infill on the glass. I print
glass using 2 perimeters, 0 top, 2 bottoms, and 20 percent
homeycomb infill. If you print glass solid, it will not allow enough
light to show through the finished model. Glass in this model prints at 5 layers at .3mm.
Glass is flipped over after printing to have the smooth, flat side
showing on the outside, although, model can be viewed from either side.