Thingiverse
Bamboo Trellis
von ADR_apg
11
Downloads
22
Likes
1
Makes
This is a trellis I made to look like a piece of bamboo. My model is about 10.5in x 3.25in but you can scale it as you see fit.
I used wooden PLA filament but you can use anything you think might look good as a piece of curved bamboo.
Took about 4 hours on an Ender5 plus running Klipper
I used wooden PLA filament but you can use anything you think might look good as a piece of curved bamboo.
Took about 4 hours on an Ender5 plus running Klipper
ADR_apg veröffentlicht auch auf
3 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
