Bambu Lab Coaster

This is not an official Bambu Lab model, but uses the published Bambu Lab™️ logo. Body and insert are separated to reduce waste due to color changes.Designed in Bambu Studio and Inkscape.License: CC-BY-NC-SA-4.0 (Creative Commons Attribution Non Commercial Share Alike 4.0 International).Dimensions: 106×6mm (⌀/H).Resources: ~2h printing time (body + insert), using 39g filament (+6g waste).The recommended color palette is this:Bambu PLA Matte Charcoal (11101)Bambu PLA Matte Scarlet Red (11200)Bambu PLA Matte Dark Red (11202)Bambu PLA Matte Grass Green (11500)AssemblyMake sure your printer produces a snug fitting insert, there should be no noticable gap to the body, but you should be able to shake the insert out again. Try this out after printing your first pair of body and insert. Then, put down a swirl of plastics superglue. Start at the center, leave at least 1cm uncovered at the rim, and don't overdo it. Fit in the insert at an angle, aligning it with the bodies raised ridge, and