Bambu P1S Cable Chain Saver

Cable Chain Saver When printing larger models on my P1S, I noticed that repeatedly the cable chain hooks behind the panel screw on the right inside, causing some concern, wear and tear, and a annoying noise. Its a known problem but the available clips and covers didn't work for me, either bad fit, potentially falling off and/or printing unreliable. So I decided to design my own, using the original screw to screw it down. **NOTE !** I digged up a slightly longer screw from my hoarding collection. The original screw will work, but barely enters the plastic from the side panel so I highly recommend finding and using a longer screw. Print in PETG or higher temp material.The settings are very conservative, high quality and very low speed so tweak at your wish.