Bambu P2S Bed clips

>>> These clips DO NOT FIT to P1S <<< HERE you will find a "bed" for those clips (which they adore;-) INTRODUCTION (with a wink ;-) What is it for? When printing large objects on the entire or almost entire surface of the plate, the printed model experiences significant material shrinkage, which causes the print to peel off the plate (most often curling up at the corners). To prevent this, brims are used, followed by adhesives. Unfortunately, shrinkage still occurs, but this time the print sticks firmly to the plate and lifts with it. I have personally seen the corners of the plate lifted by as much as 10 mm. That is why clips are needed to hold the plate in place, reducing possible deformation of the print walls or print failure. Allow me to introduce you to a group of six handsome and extremely helpful plate holders. They have known each other for a long time and have held many things in their lives. They are brave, strong and invincible. It is difficult to find better printing compa