Bambu PLA Matte Filament Sample Cards

Filament sample cards for Bambu PLA Matte filament. This can be a somewhat tricky print because of the 0.1mm first layer. The default Bambu PLA Matte flow ratio is sometimes a little bit too low, and increasing this slightly (ie: from 0.98 to 1.00) can help a lot. Increasing the 1st layer temp by 10 degrees and making sure you have a clean bed will also help. This is a ground-up recreation of @fenglyu's Filament Sample Card design. The outer dimensions, corner radius, and hanger clips match the existing design while the inner area was redesigned to highlight printed text instead of an adhesive label.