Bambu PLA Silk+ Filament Sample Cards

Filament sample cards for Bambu PLA Silk+ filament.This can be a somewhat tricky print because of the 0.1mm first layer. The default Bambu PLA flow ratio is sometimes a little bit too low, and increasing this slightly (ie: from 0.98 to 1.00) can help a lot. Increasing the 1st layer temp by 10 degrees and making sure you have a clean bed will also help. This is a ground-up replacement for @fenglyu's Filament Sample Card design, compatible with most accessories for their standard-sized swatches. The outer dimensions, corner radius, and hanger clips match the existing design while the inner area was redesigned to highlight printed text instead of an adhesive label.