Bambu Poop Chute

This chute is designed to redirect to this poop bucket that can be place fully alongside the printer: Bambu Big Boy Poop Bucket by adriangarside - MakerWorld or it can be directed straight off the edge of the desk in a floor bucket. Filament usage: I wanted one that was light on filament and smaller than many of the ones I see that are kinda big for the tiny poops the machine spits out in one go. The original thin one comes in about 30g and takes about 47 minutes to print with high flow PLA or about an hour with generic PLA. How it attaches: The earlier prototypes using the weaksauce magnet strips that came with the printer for the scraper just wouldn't stay in place. Instead I simply attached with a good double side sticky tape as I needed it to survive the P1P being placed into an enclosure without moving or being knocked out of alignment. There are remixes that have built in space for magnets to be glued but that means the wall against the printer has to be thickened which might res