Bambu studio - Temperature tower (All)

Working with PETG on a Bambu X1, I needed a temperature tower with G-code to work in Bambu Studio. The general PETG presets work, but I want to explore faster prints. This temperature tower originates from the work of Tronnic and Kryštof.The machine g-code is added based on the Bambu manual.Temperature starts from 250 degrees C, as I noticed at lower temperatures the result is to crappy and the base breaks off. My current adjustments for eSun PETG (for reference only); Filament settings: Nozzle 280 Celsius, bed 65 C, max flow 18mm2, z-hop enabled.Profile settings: outer wall and surface speed 180 mms. I noticed black is the worst performing colour and e.g. white or yellow perform a lot better. this both in max flow (21mm2 vs 28mm2) and in max acceleration it can handle. Using a higher temperature can compensate a bit for this, as shown by the temp towers. Acceleration seems the most limiting factor in case of the black PETG I tested. 10.000 is just way more than it can handle, so proba