Slicer Discord
Banana Slicer v1 – 3D-printbaar model van MakerOnline MakerOnline
Banana Slicer v1 – Bild 1 Banana Slicer v1 – Bild 2 Banana Slicer v1 – Bild 3
Household

Banana Slicer v1

11 Downloads
7 Likes
0 Makes
Model downloaden
My wife needed to slice a bunch of bananas for pudding. Normally she does it with a paring knife, and 2 out of 10 times manages to cut herself. Created this to make the job easier and faster.  The banana in the picture was a little less ripe than it should have been, still works fine by pushing down on both long edges through the banana, flip it over and run your thumb along the banana to finish the slice. Drops off nicely into a bowl or cutting board. If you try to cut a very green banana, don't be surprised if it doesn't work or breaks. The cutting edge is strong, but needs to be narrow to cleanly cut. There are a bunch (pun intended) of banana slicers but they tried to be “banana shaped” and that seemed like it was only good if the banana wasn't too long, too curved, etc., so, this one should accommodate pretty much any banana, even really long ones can be cut twice.
Categorie
Household
Bron
MakerOnline
Gepubliceerd
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie