Bar Clamp Round Protective Pad

Replacement pad for bar clamp with the round pad. To replace the grey cover that easily falls off and gets lost since it's a hard plastic and doesn't fit all that well to begin with.

Printed in TPU so it's flexible so it can be put on or removed but still soft enough to offer some protection for the object being clamped.

I used 2 perimeter shells and 3 top & bottom just because it was set to 2 outside shells from a previous project otherwise I would have used 3. Used 50% infill.

It's a tight fit and shouldn't get lost. Even if 1 does get lost it's less than 1/2 hour to make a new one.