barbell collar

printed with tpu for grip and petg for strength on non-flexible parts

you will need:
print 2 TPU side pieces and one of every other part

TPU parts include:
2x barbell_collar_tpu_side.stl
a barbell_collar_tpu_front_hinge.stl
and a barbell_collar_tpu_rear_hinge.stl

PETG parts include:
a barbell_collar_latch.stl
a barbell_collar_top_left.stl
a barbell_collar_bottom_left.stl
a barbell_collar_top_right.stl
and a barbell_collar_bottom_right.stl

6 m6x40 bolts with nuts
2 m3 bolts with nuts
you will need a 2mm x 12mm long pin for the latch to pivot on. I used a nail with both ends ground off

the fit for the nut will be tight. use the screws to pull nuts into place.

instructions
1)insert the nuts on the inside of the latch
2)insert the front hinge into the latch and run pin through both parts
3) insert nuts on top right and left petg parts
4)line up each side one at a time with corresponding top, bottom, and a TPU side piece
5)tighten (do not overly tighten, th