Thingiverse
Barbell wall clip
door tomos_lono
7
Downloads
5
Likes
0
Makes
A wall mountable clip for a barbell that measures 28 mm at the smooth grip part of the bar. Requires only one at the top in order for the barbell to stay upright without any external disturbances, print a second one for the bottom as well if you're worried about stability. To be fastened with two 4 mm screws.
Tested only in PETG, not sure if PLA would be too rigid for it to work properly. First iteration had a 2 mm tighter opening, which caused the part to crack when fitted onto the bar, so any material less flexible than PETG might cause problems.
Tested only in PETG, not sure if PLA would be too rigid for it to work properly. First iteration had a 2 mm tighter opening, which caused the part to crack when fitted onto the bar, so any material less flexible than PETG might cause problems.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
