Thingiverse
Barebow Inspection Ring
von -BKR-
39
Downloads
32
Likes
1
Makes
My Version of an Inspection RIng to quickly check if different Weights fit the 122mm Rule in Barebow.
My print turned out to be 121.8mm. This and the Ring being thicker than the Official Tool should make sure that if it fits my Ring it will pass through inspection too.
Don´t blame me if it doesn´t ;
Update: Added a thinner Version with a Hole of 9.4mm. Use it to tie a Piece of Rope to it or check Point Diameter.
My print turned out to be 121.8mm. This and the Ring being thicker than the Official Tool should make sure that if it fits my Ring it will pass through inspection too.
Don´t blame me if it doesn´t ;
Update: Added a thinner Version with a Hole of 9.4mm. Use it to tie a Piece of Rope to it or check Point Diameter.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
