Thingiverse
Barrel Nerf Mediator
door Mountainborn
9
Downloads
4
Likes
0
Makes
created this Nozzle to customize my sons Nerf Mediator
Prints in Parts:
- Body-part: printed with supports to have a clean edge that goes against the nozzle. But could be done without.
- Barrel: printed upright with Brim for extra support.
- Nozzle, printed upright (nozzle side down), printed with supports to have a clean edge that goes against the nozzle. But could be done without.
The Barrel might need a bit of sanding to go properly in the original Nerf Nozzle. Also, it's a pretty tight fit in the the Body and Nozzle. For easier connection, print in 99%.
Also check out the stock: https://www.thingiverse.com/thing:4835094
Prints in Parts:
- Body-part: printed with supports to have a clean edge that goes against the nozzle. But could be done without.
- Barrel: printed upright with Brim for extra support.
- Nozzle, printed upright (nozzle side down), printed with supports to have a clean edge that goes against the nozzle. But could be done without.
The Barrel might need a bit of sanding to go properly in the original Nerf Nozzle. Also, it's a pretty tight fit in the the Body and Nozzle. For easier connection, print in 99%.
Also check out the stock: https://www.thingiverse.com/thing:4835094
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
