Barrel Tap

A barrel tap for an outside water barrel in your garden, although it may have other uses too.

There are several parts to this and some you will need to print multiple times.

| Part | # | Material | Notes |
| ----------- | ----------- | ----------- | ----------- |
| barrel_tap | x1 | PETG | This is the main part of the tap that inserts into the barrel |
| barrel_tap_plug | x1 | PETG | The movable part that screws into the tap to stop the flow of water |
| barrel_tap_nut | x2 | PETG | These nuts screw onto the barrel_tap part inside the barrel. You may get away with just one, but I used two for extra strength. |
| barrel_tap_washer | x2 | TPU | These washers seal the tap to the barrel. Place one inside and one outside. Print with only 1 wall layer to make them extra squishy. |
| barrel_tap_plug_washer | x1 | TPU | This small washer goes on the end of barrel_tap_plug and seals the plug against the inside of the tap to ens