Thingiverse
Base Attachment Anet A8
door losredoe132
928
Downloads
693
Likes
6
Makes
A simple attachment to fix the Anet A8 or other printer to the basement. My threaded rods were a little bit bend so i made these straightforward attachment to mount the printer on a wooden plate. Between this plate and the tabletop I put four rubber bands, to protect the surface from scratches and decrease vibrations a little. I've used six of them, but four should be sufficient. The more, the better...
You should refrain from using countersunk screws to avoid splitting. A better option is to use cylinder head screws or washers.
You should refrain from using countersunk screws to avoid splitting. A better option is to use cylinder head screws or washers.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
