Base Extender for LED Bridge Light Mini

The arch was a bit too short for painting miniatures on a handle, so I made it taller without making it much wider.

I don't know that this technically counts as a remix because I modeled it from scratch, but I figured it would be better to link it this way so it stays attached to what it's supposed to be used with.

This is an extender that moves the arch about two inches upward and braces the ends a bit better with wider bases. It has a hole for the wire to continue out the bottom.

Just set the original arch in the slots in these bases, run the wire through the hole, and you should be good to go.