Base for PTSolns Proto-Full

Proto-Full Base

Base can be mounted as it has two chamfered M3 holes, and four #8 screw holes.

To install the brass inserts:
- Place nut over tip of soldering iron (pointy tip). Let heat up for just a few seconds.
- Make sure the up side, is down on the iron, or the nut will be installed upside down.
- Gently press the nut into the 3D printed standoff. Don't push all the way, stop when the nut is about 1mm out.
- Use a small piece of PCB or something else flat and firm to press the nut in the rest of the way.
- Reheat with iron if it cooled too much. Go slow and low heat.

Find product documentation and supporting material on our Documentation Subdomain: docs.PTSolns.com

RESOURCES

PTSolns Proto-Full:
https://ptsolns.com/products/proto-full

Datasheets & supporting material on PTSolns Documentation Repository:
https://docs.ptsolns.com

PTSolns website:
https://ptsolns.com

PTSolns Distributors:
https://ptsolns.com/distributors

PTSolns Product Catalog:
https://ptsolns.com/catalog