Thingiverse
Base for roll
von rmvazquez
0
Downloads
0
Likes
0
Makes
This is a base for a 120mm roll for any printer. It is meant to sit at the side of the printer and have the filament roll without moving. It is recommended to print it oriented as it comes to let the layers create little paths for the roll to move more easily bearing in minds that it lives overhangs. I did print it without supports and it did it just fine but test it out
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
