Thingiverse
Bases for Lancer TTRPG
0
Downloads
0
Likes
1
Makes
Set of bases that I modeled for use in the Lancer TTRPG by Massif Press. Bases are 1" across at parallel sides for each hex, and a given side is just over half an inch.
I have successfully printed and used the size 1, 2, and 3 bases on my Photon Mono X2 resin printer, supported files I made for those prints are included. Bases are hollow on the bottom to allow use of a small magnet or adhesion of heavier material to weigh the base down.
Size 1, 2, 3, and 4 bases are included here.
I have successfully printed and used the size 1, 2, and 3 bases on my Photon Mono X2 resin printer, supported files I made for those prints are included. Bases are hollow on the bottom to allow use of a small magnet or adhesion of heavier material to weigh the base down.
Size 1, 2, 3, and 4 bases are included here.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
