Basic Case for Sony Xperia Z1 Compact

UPDATE to V4:

- Hole for wrist strap created to match the one on the phone (bottom right corner).
- Camera shutter button is more accessible
- The frame protects slightly the phone when laying flat upside down, but it does not protrudes much, so careful there.


UPDATE to V3:

V2 has been deleted, and the newest V3 is already fixed. The problems described below should no longer apply. I haven't printed this new version but I will as soon as I get new Filament. The case is improved and some areas too.

(FIXED) UPDATE:

OK so I tested this design (File Version #2) and I have a couple of improvements to Do.
1. Is that the secondary microphone is covered by the case (I made a measurement mistake of 1mm)
2. The front of the phone is not protected, the frame sits flushed with the device and this is not so good.

So I will update soon with the corrections and I will print a new Black case for my dad and probably a purple one for my wife since she wants to buy that phone as